Reply To: Wacom digitizer and antix boot

Forum › Forums › Orphaned Posts › antiX-17 “Heather Heyer, Helen Keller” › Wacom digitizer and antix boot – [solved] › Reply To: Wacom digitizer and antix boot

June 3, 2018 at 6:50 pm #10660
Member
stevesr0
    Helpful
    Up
    0
    ::

    re: find the module for wacom and blacklist it.

    lsmod doesn’t show any wacom modules.

    I found four wacom modules in three subdirectories of /lib/modules/4.987-antix17.1-amd64-smp/kernel/drivers.

    The files are /hid/wacom.ko, /input/tablet/wacom_serial4.ko, input/touchscreen/wacom_12c.ko and /input/touchscreen/wacom_w8001.ko.

    I read that modules should show up unless they are listed in the file modules.builtin. Wacom is not listed in that file, but doesn’t show up when I run lsmod.

    ***I would like to try disabling/removing/blacklisting these modules at boot. However, so far, when I try to edit the option “bar” displayed by the F12 key, there is no change in the boot process. Perhaps, I am not editing properly. The help section says using F12 to display the options and then deleting an option will remove it from the boot. I tried this with the default “quiet” option, but when I then started the boot, it still used the “quiet” option.

    (I won’t start another thread about the failure to edit live usb boot options, although it seems like a separate issue. I just searched the forum and didn’t see any threads about this).

    Appreciate any comments, responses, advice and/or assistance.

    Thanks in advance.

    Steve

    • This reply was modified 4 years, 11 months ago by stevesr0.
    • This reply was modified 4 years, 11 months ago by rokytnji.