Problem Ceni

[Member wasp]

On Antix 19, I uninstalled connman and installed Ceni, but it connects but doesn’t browse.

/etc/network/interfaces:

# interfaces(5) file used by ifup(8) and ifdown(8)
auto lo
iface lo inet loopback

Thanks

[Forum Admin anticapitalista]

Helpful

Up

0

::

Did you reboot?

Philosophers have interpreted the world in many ways; the point is to change it.

antiX with runit - leaner and meaner.

[Member wasp]

Helpful

Up

0

::

anticapitalista wrote:

Did you reboot?

Yes, but nothing…

[Forum Admin rokytnji]

Helpful

Up

0

::

Hmmm.

ifconfig -a

say anthing?

Sometimes I drive a crooked road to get my mind straight.
Not all who Wander are Lost.
I'm not outa place. I'm from outer space.

Linux Registered User # 475019
How to Search for AntiX solutions to your problems

[Member wasp]

Helpful

Up

0

::

Ifconfig -a :

eth0: flags=4098<BROADCAST,MULTICAST> mtu 1500
ether 00:24:54:ca:bc:a0 txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 19

lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
loop txqueuelen 1 (Local Loopback)
RX packets 260 bytes 14184 (13.8 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 260 bytes 14184 (13.8 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0

wlan0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
ether e8:39:df:d9:17:ad txqueuelen 1000 (Ethernet)
RX packets 0 bytes 0 (0.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 0 bytes 0 (0.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 16

[Forum Admin anticapitalista]

Helpful

Up

0

::

If you use ceni, then it makes changes to the /etc/network/interfaces file.
Yours doesn’t show any changes.

Philosophers have interpreted the world in many ways; the point is to change it.

antiX with runit - leaner and meaner.

[Member wasp]

Helpful

Up

0

::

The complete file also has the correct parameters, but connects and does not navigate … hi removed connman …

allow-hotplug wlan0
iface wlan0 inet dhcp
wpa-essid SImons67
wpa-psk [Password]

Thanks

• This reply was modified 3 years, 6 months ago by wasp.

[Author]

Posts