Startup service screen numbers X

Forum › Forums › New users › New Users and General Questions › Startup service screen numbers X

  • This topic has 2 replies, 2 voices, and was last updated Sep 28-12:55 am by ex_Koo.
Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • September 27, 2020 at 5:41 pm #42305
    Member
    ex_Koo

      Just have a question about the startup service screen. What do the numbers mean at the top of the screen. ?
      S is start but why are their X in the numbers boxes. I run mpd with ncmpcpp which by the way works fine, but 2 , 3 , 4 , 5 are marked with X but not S.
      Is it like a time delay or something as their is always a delay in mpd service starting . Can not fined anything about this..
      service 1 2 3 4 5 0 6 S

      September 27, 2020 at 8:37 pm #42307
      Anonymous
        Helpful
        Up
        0
        ::

        I’m not familiar with “ncmpcpp”
        but it sounds like you are referring to “runlevels”, described here: https://wiki.debian.org/RunLevel

        $ sudo sysv-rc-conf

        Via the sysv-rc-conf interface, you can view and (re)configure which services (daemons) are slated to autostart each time the system enters a (each) given runlevel.
        tip: individual changes [X] are saved immediately; when finished, press Q to quit the sysv-rc-conf program

        $ runlevel

        This command will display the current system runlevel

        September 28, 2020 at 12:55 am #42308
        Member
        ex_Koo
          Helpful
          Up
          0
          ::

          I was not even close to the answer. Thanks skidoo

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.